R0K572030S000BE Renesas Electronics America, R0K572030S000BE Datasheet - Page 1086

• Manufacturer Part Number: R0K572030S000BE
• Description: KIT DEV FOR SH7203
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K572030S000BE

• Contents: CPU Board, LCD Module, E10A-Lite Emulator, Cable, QuickStart Guide and CD-ROM
• Silicon Manufacturer: Renesas
• Kit Contents: Board
• Silicon Family Name: SH7203
• Silicon Core Number: R5S72030W200FP
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Mcu Supported Families: SH7203
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: SH7203
• Lead Free Status / Rohs Status: Compliant

Section 22 AND/NAND Flash Memory Controller (FLCTL)
(3)
• Command access mode: Performs an access by specifying a command to be issued from the
• Sector access mode: Performs a read or write in sector units by specifying a sector and controls
(4)
• A sector is the basic unit of access and comprised of 512-byte data and 16-byte control code.
• The position of the ECC in the control code can be specified in 4-byte units.
• User information can be written to the control code other than the ECC.
(5)
• 8-byte ECC code is generated and error check is performed for a sector (512-byte data + 16-
• Error correction capability is up to three errors.
• In a write operation, an ECC code is generated for data and control code prior to the ECC. The
• In a read operation, an ECC error is checked for data and control code prior to the ECC. An
• An error correction is not performed even when an ECC error occurs. Error corrections must
(6)
• When a program error or erase error occurs, the error is reflected on the error source flags.
• When a read error occurs, an ECC in the control code is other than 0. This read error is
• When an ECC error occurs, perform an error correction, specify another sector to be replaced,
Rev. 3.00 Sep. 28, 2009 Page 1054 of 1650
REJ09B0313-0300
FLCTL to flash memory, address, and data size to be input or output. Read, write, or erasure of
data without ECC processing can be achieved.
ECC-code generation and check. By specifying the number of sectors, the continuous sectors
can be read or written.
The 16-byte control code includes 8-byte ECC.
byte control code). (Note that the ECC code generation in the 16-byte control code and the
number of bytes to be checked differ depending on the specifications.)
control code following the ECC is not considered.
ECC on the control code in the FIFO is replaced with the check result by the ECC circuit, not
an ECC code read from flash memory.
be performed by software.
Interrupts for each source can be specified.
reflected on the ECC error source flag.
and copy the contents of the block to another sector as required.
Access Modes: The FLCTL can select one of the following two access modes.
Sectors and Control Codes
ECC
Data Error