MC912D60CCPVE Freescale Semiconductor, MC912D60CCPVE Datasheet - Page 388

• Manufacturer Part Number: MC912D60CCPVE
• Description: IC MCU 16BIT 112-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC12r

Specifications of MC912D60CCPVE

• Core Processor: CPU12
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: CAN, MI Bus, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 68
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 1K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x8/10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 112-LQFP
• Processor Series: HC912D
• Core: HC12
• Data Bus Width: 16 bit
• Data Ram Size: 2 KB
• Interface Type: CAN, SCI, SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 86
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: EWHCS12
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 8 Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Development Support
19.4.5.1 STATUS
STATUS— BDM Status Register
Technical Data
388
RESET:
RESET:
1. ENBDM is set to 1 by the firmware in Special Single Chip mode.
(NOTE 1)
ENBDM
BIT 7
0
0
BDMACT
6
1
0
The only registers of interest to users are the STATUS register and the
CCRSAV register. The other BDM registers are only used by the BDM
firmware to execute commands. The registers are accessed by means
of the hardware READ_BD and WRITE_BD commands, but should not
be written during BDM operation (except the CCRSAV register which
could be written to modify the CCR value).
The STATUS register is read and written by the BDM hardware as a
result of serial data shifted in on the BKGD pin.
Read: all modes.
Write: Bits 3 through 5, and bit 7 are writable in all modes. Bit 6,
BDMACT, can only be written if bit 7 H/F in the INSTRUCTION register
is a zero. Bit 2, CLKSW, can only be written if bit 7 H/F in the
INSTRUCTION register is a one. A user would never write ones to bits
3 through 5 because these bits are only used by BDM firmware.
ENBDM — Enable BDM (permit active background debug mode)
•
•
(1)
ENTAG
0 = BDM cannot be made active (hardware commands still
1 = BDM can be made active to allow firmware commands.
The ADDRESS register is temporary storage for BDM commands.
The CCRSAV register preserves the content of the CPU12 CCR
while BDM is active.
5
0
0
allowed).
Development Support
SDV
4
0
0
TRACE
3
0
0
CLKSW
2
0
0
1
0
0
-
MC68HC912D60A — Rev. 3.1
Freescale Semiconductor
BIT 0
0
0
-
Special Sin-
& Periph
gle Chip
All other
modes
$FF01