HD64F7050 RENESAS [Renesas Technology Corp], HD64F7050 Datasheet - Page 122

• Manufacturer Part Number: HD64F7050
• Description: 32-Bit RISC Microcomputer SuperH RISC engine Family/
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 7 User Break Controller (UBC)
7.3
7.3.1
The flow from setting of break conditions to user break interrupt exception processing is described
below:
1. The user break addresses are set in the user break address register (UBAR), the desired masked
2. The UBC uses the method shown in figure 7.2 to judge whether set conditions have been
3. The interrupt controller checks the accepted user break interrupt request signal’s priority level.
4. The INTC sends the user break interrupt request signal to the CPU, which begins user break
Rev. 5.00 Jan 06, 2006 page 102 of 818
REJ09B0273-0500
bits in the addresses are set in the user break address mask register (UBAMR) and the breaking
bus cycle type is set in the user break bus cycle register (UBBR). If even one of the three
groups of the UBBR’s CPU cycle/peripheral cycle select bits (CP1, CP0), instruction
fetch/data access select bits (ID1, ID0), and read/write select bits (RW1, RW0) is set to 00 (no
user break interrupt is generated), no user break interrupt will be generated even if all other
conditions are in agreement. When using user break interrupts, always be certain to establish
bit conditions for all of these three groups.
fulfilled. When the set conditions are satisfied, the UBC sends a user break interrupt request
signal to the interrupt controller (INTC).
The user break interrupt has priority level 15, so it is accepted only if the interrupt mask level
in bits I3–I0 in the status register (SR) is 14 or lower. When the I3–I0 bit level is 15, the user
break interrupt cannot be accepted but it is held pending until user break interrupt exception
processing can be carried out. Consequently, user break interrupts within NMI exception
service routines cannot be accepted, since the I3–I0 bit level is 15. However, if the I3–I0 bit
level is changed to 14 or lower at the start of the NMI exception service routine, user break
interrupts become acceptable thereafter. Section 6, Interrupt Controller, describes the handling
of priority levels in greater detail.
interrupt exception processing upon receipt. See Section 6.4, Interrupt Operation, for details on
interrupt exception processing.
Operation
Flow of the User Break Operation