HD64F7050 RENESAS [Renesas Technology Corp], HD64F7050 Datasheet - Page 440

• Manufacturer Part Number: HD64F7050
• Description: 32-Bit RISC Microcomputer SuperH RISC engine Family/
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 13 Serial Communication Interface (SCI)
Receiving Serial Data (Clock Synchronous Mode): Figure 13.20 shows a sample flowchart for
receiving serial data. When switching from the asynchronous mode to the clock synchronous
mode, make sure that ORER, PER, and FER are cleared to 0. If PER or FER is set to 1, the RDRF
bit will not be set and both transmitting and receiving will be disabled.
The procedure for receiving serial data is listed below:
1. SCI initialization: Set the RxD pin using the PFC.
2. Receive error handling: If a receive error occurs, read the ORER bit in SSR to identify the
3. SCI status check and receive data read: Read the serial status register (SSR), check that RDRF
4. Continue receiving serial data: Read RDR, and clear RDRF to 0 before the frame MSB (bit 7)
Rev. 5.00 Jan 06, 2006 page 420 of 818
REJ09B0273-0500
error. After executing the necessary error handling, clear ORER to 0. Transmitting/receiving
cannot resume if ORER remains set to 1.
is set to 1, then read receive data from the receive data register (RDR) and clear RDRF to 0.
The RxI interrupt can also be used to determine if the RDRF bit has changed from 0 to 1.
of the current frame is received. If the DMAC is started by a receive-data-full interrupt (RxI)
to read RDR, the RDRF bit is cleared automatically so this step is unnecessary.