HD64F7050 RENESAS [Renesas Technology Corp], HD64F7050 Datasheet - Page 167

• Manufacturer Part Number: HD64F7050
• Description: 32-Bit RISC Microcomputer SuperH RISC engine Family/
• Manufacturer: RENESAS [Renesas Technology Corp]

Bit 5—Transfer Mode (TM): Specifies the bus mode for data transfer.
Bits 4 and 3—Transfer Size 1, 0 (TS1, TS0): Specifies size of data for transfer.
Bit 2—Interrupt Enable (IE): When this bit is set to 1, interrupt requests are generated after the
number of data transfers specified in the DMATCR (when TE = 1).
Bit 1—Transfer End (TE): This bit is set to 1 after the number of data transfers specified by the
DMATCR. At this time, if the IE bit is set to 1, an interrupt request is generated.
If data transfer ends before TE is set to 1 (for example, due to an NMI or address error, or clearing
of the DE bit or DME bit of the DMAOR) the TE is not set to 1. With this bit set to 1, data transfer
is disabled even if the DE bit is set to 1.
Bit 5: TM
0
1
Bit 4: TS1
0
0
1
1
Bit 2: IE
0
1
Bit 1: TE
0
1
Bit 3: TS0
0
1
0
1
Description
Interrupt request not generated after DMATCR-specified transfer count
(initial value)
Interrupt request enabled on completion of DMATCR specified number
of transfers
Description
DMATCR-specified transfer count not ended (initial value)
Clear condition: 0 write after TE = 1 read, Power-on reset, standby
mode
DMATCR specified number of transfers completed
Description
Cycle steal mode (initial value)
Burst mode
Description
Specifies byte size (8 bits) (initial value)
Specifies word size (16 bits)
Specifies longword size (32 bits)
Prohibited
Section 9 Direct Memory Access Controller (DMAC)
Rev. 5.00 Jan 06, 2006 page 147 of 818
REJ09B0273-0500