LFEBS12UB Freescale Semiconductor, LFEBS12UB Datasheet - Page 1000

• Manufacturer Part Number: LFEBS12UB
• Description: KIT STUDENT LEARNING S12 DG128
• Manufacturer: Freescale Semiconductor

Specifications of LFEBS12UB

• Architecture: 8/16-bit
• Code Gen Tools Included: Code Warrior
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12D
• Kit Contents: HCS12 DG128 Learning Kit
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Chapter 26 384 KByte Flash Module (S12XFTM384K2V1)
26.4.2.10 Erase P-Flash Sector Command
The Erase P-Flash Sector operation will erase all addresses in a P-Flash sector.
Upon clearing CCIF to launch the Erase P-Flash Sector command, the Memory Controller will erase the
selected Flash sector and then verify that it is erased. The CCIF flag will be set after the Erase P-Flash
Sector operation has completed.
26.4.2.11 Unsecure Flash Command
The Unsecure Flash command will erase the entire P-Flash and D-Flash memory space and, if the erase is
successful, will release security.
Upon clearing CCIF to launch the Unsecure Flash command, the Memory Controller will erase the entire
P-Flash and D-Flash memory space and verify that it is erased. If the Memory Controller verifies that the
entire Flash memory space was properly erased, security will be released. If the erase verify is not
successful, the Unsecure Flash operation sets MGSTAT1 and terminates without changing the security
1000
1. As defined by the memory map for FTM512K3.
FERSTAT
Register
FSTAT
CCOBIX[2:0]
Table 26-51. Erase P-Flash Sector Command FCCOB Requirements
CCOBIX[2:0]
MGSTAT1
MGSTAT0
EPVIOLIF
Table 26-53. Unsecure Flash Command FCCOB Requirements
ACCERR
Error Bit
000
001
FPVIOL
Table 26-52. Erase P-Flash Sector Command Error Handling
000
MC9S12XE-Family Reference Manual , Rev. 1.23
Global address [15:0] anywhere within the sector to be erased.
Set if CCOBIX[2:0] != 001 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if an invalid global address [22:16] is supplied
Set if a misaligned phrase address is supplied (global address [2:0] != 000)
Set if the selected P-Flash sector is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
None
Refer to
0x0A
0x0B
Section 26.1.2.1
FCCOB Parameters
FCCOB Parameters
Global address [22:16] to identify
for the P-Flash sector size.
Error Condition
P-Flash block to be erased
Not required
(1)
Table
26-30)
Freescale Semiconductor