LFEBS12UB Freescale Semiconductor, LFEBS12UB Datasheet - Page 759

• Manufacturer Part Number: LFEBS12UB
• Description: KIT STUDENT LEARNING S12 DG128
• Manufacturer: Freescale Semiconductor

Specifications of LFEBS12UB

• Architecture: 8/16-bit
• Code Gen Tools Included: Code Warrior
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12D
• Kit Contents: HCS12 DG128 Learning Kit
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Enable single-wire operation by setting the LOOPS bit and the receiver source bit, RSRC, in SCI control
register 1 (SCICR1). Setting the LOOPS bit disables the path from the RXD pin to the receiver. Setting
the RSRC bit connects the TXD pin to the receiver. Both the transmitter and receiver must be enabled
(TE = 1 and RE = 1).The TXDIR bit (SCISR2[1]) determines whether the TXD pin is going to be used as
an input (TXDIR = 0) or an output (TXDIR = 1) in this mode of operation.
20.4.8
In loop operation the transmitter output goes to the receiver input. The RXD pin is disconnected from the
SCI.
Enable loop operation by setting the LOOPS bit and clearing the RSRC bit in SCI control register 1
(SCICR1). Setting the LOOPS bit disables the path from the RXD pin to the receiver. Clearing the RSRC
bit connects the transmitter output to the receiver input. Both the transmitter and receiver must be enabled
(TE = 1 and RE = 1).
20.5
20.5.1
See
20.5.2
20.5.2.1
Normal mode of operation.
To initialize a SCI transmission, see
Freescale Semiconductor
Because of an order from the United States International Trade Commission, BGA-packaged product lines and partnumbers
indicated here currently are not available from Freescale for import or sale in the United States prior to September 2010
Section 20.3.2, “Register
Initialization/Application Information
Loop Operation
Reset Initialization
Modes of Operation
Run Mode
In single-wire operation data from the TXD pin is inverted if RXPOL is set.
In loop operation data from the transmitter is not recognized by the receiver
if RXPOL and TXPOL are not the same.
Figure 20-31. Loop Operation (LOOPS = 1, RSRC = 0)
Descriptions”.
MC9S12XE-Family Reference Manual Rev. 1.23
Transmitter
Section 20.4.5.2, “Character
Receiver
NOTE
NOTE
Chapter 20 Serial Communication Interface (S12SCIV5)
Transmission”.
RXD
TXD
759