DF2345TE20 Renesas Electronics America, DF2345TE20 Datasheet - Page 512

• Manufacturer Part Number: DF2345TE20
• Description: MCU 5V 128K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2345TE20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 71
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2345TE20; HD64F2345TE20

Section 13 Smart Card Interface
13.3
13.3.1
The main functions of the Smart Card interface are as follows.
13.3.2
Figure 13.2 shows a schematic diagram of Smart Card interface related pin connections.
In communication with an IC card, since both transmission and reception are carried out on a
single data transmission line, the TxD pin and RxD pin should be connected with the LSI pin. The
data transmission line should be pulled up to the V
When the clock generated on the Smart Card interface is used by an IC card, the SCK pin output is
input to the CLK pin of the IC card. No connection is needed if the IC card uses an internal clock.
LSI port output is used as the reset signal.
Other pins must normally be connected to the power supply or ground.
Rev. 4.00 Feb 15, 2006 page 486 of 900
REJ09B0291-0400
One frame consists of 8-bit data plus a parity bit.
In transmission, a guard time of at least 2 etu (Elementary Time Unit: the time for transfer of
one bit) is left between the end of the parity bit and the start of the next frame.
If a parity error is detected during reception, a low error signal level is output for one etu
period, 10.5 etu after the start bit.
If the error signal is sampled during transmission, the same data is transmitted automatically
after the elapse of 2 etu or longer.
Only start-stop asynchronous communication is supported; there is no clocked synchronous
communication function.
Operation
Overview
Pin Connections
CC
power supply with a resistor.