DS3163 Maxim Integrated Products, DS3163 Datasheet - Page 103

• Manufacturer Part Number: DS3163
• Description: IC TRPL ATM/PACKET PHY 400-PBGA
• Manufacturer: Maxim Integrated Products

Specifications of DS3163

• Applications: *
• Mounting Type: Surface Mount
• Package / Case: 400-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DS3161/DS3162/DS3163/DS3164
creating a positive or negative clock edge for each payload bit, the receive gapped clock is created by the logical
OR of the RCLKOn and RDENn signals.
When the output clock is disabled, the gapped output signal is high during clock periods if the pin is not inverted;
otherwise it will be low.
The gapped clocks are very useful when the data being clocked does not need to be aligned with any frame
structure. The data is simply clocked one bit at a time as a continuous data stream.
10.3 Reset and Power-Down
The device can be reset at a global level via the GL.CR1.RST bit or the RST pin and at the port level via the
PORT.CR1.RST bit and each port can be explicitly powered down via the PORT.CR1.PD bit. The JTAG logic is
reset using the JTRST pin.
The external RST pin and the global reset bit in the global configuration register (GL.CR1.RST) are combined to
create an internal global reset signal. The global reset signal resets all the status and control registers on the chip,
except the GL.CR1.RST bit, to their default values and resets all the other flops in the system bus interface, global
logic and ports to their reset values. The processor bus output signals are also forced to be HIZ when the RST pin
is active (low). The global reset bit (GL.CR1.RST) stays set after a one is written to it, but is reset to zero when the
external RST pin is active or when a zero is written to it.
At the port level, the global reset signal combines with the port reset bit in the port control register
(PORT.CR1.RST) to create a port reset signal. The port reset signal resets all the status and control registers on
the port to their default values and resets all the other flops, except PORT.CR1.RST, to their reset values. The port
reset bit (PORT.CR1.RST) stays set after a one is written to it, but is reset to zero when the global reset signal is
active or when a zero is written to it.
The data path reset function is a little different from the “general” reset function. The data path reset signal does not
reset the control register bits, but it does reset all of the status registers, counters and flops, the “general” reset
signal resets everything including the control register bits, excluding the reset bit. All clocks are functional, being
controlled by configuration bits, while data path reset is active. The CLAD circuit will be operating normally during
data path reset which allows the internal phase locked loops to settle as quickly as possible. The line interface will
be sending all zeroes (LOS) since data path reset will be forcing the transmit TPOSn and TNEGn to logic zero.
(NOTE: The BERT data path and control registers are reset when the global data path reset or the port data path
reset or the port power-down signal is active.)
The global data path reset bit (GL.CR1.RSTDP) gets set to one when the global reset signal is active. The port
data path reset bit (PORT.CR1.RSTDP) and the port power-down bit (PORT.CR1.PD) bit get set to one when the
global reset signal is active or the port reset signal is active. These control bits will be cleared when a zero is
written to them if the global reset or the port reset signal is not active. The global data path reset signal is active
when the global data path reset bit is set. The port data path reset signal is active when either the global data path
reset bit or the port data path reset bit is set. The port power-down signal is active when the port power-down bit is
set.