MK30DN512ZVLK10 Freescale Semiconductor, MK30DN512ZVLK10 Datasheet - Page 1109

• Manufacturer Part Number: MK30DN512ZVLK10
• Description: ARM Microcontrollers - MCU KINETIS 512K SLCD
• Manufacturer: Freescale Semiconductor

Specifications of MK30DN512ZVLK10

• Core: ARM Cortex M4
• Processor Series: K30
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 128 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.71 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-80
• Mounting Style: SMD/SMT

It is recommended to keep the baud rate the same while using the Continuous SCK.
Switching clock polarity between frames while using Continuous SCK can cause errors
in the transfer. Continuous SCK operation is not guaranteed if the DSPI is put into the
External Stop mode or Module Disable mode.
Enabling Continuous SCK disables the PCS to SCK delay and the Delay after Transfer
(t
Continuous SCK format with Continuous Selection disabled.
If the CONT bit in the TX FIFO entry is set, PCS remains asserted between the transfers.
Under certain conditions, SCK can continue with PCS asserted, but with no data being
shifted out of SOUT (SOUT pulled high). This can cause the slave to receive incorrect
data. Those conditions include:
Freescale Semiconductor, Inc.
DT
• When the DSPI is in SPI configuration, CTAR0 is used initially. At the start of each
• In all configurations, the currently selected CTAR remains in use until the start of a
• Continuous SCK with CONT bit set, but no data in the transmit FIFO.
) is fixed to one SCK cycle. The following figure is the timing diagram for
SPI frame transfer, the CTAR specified by the CTAS for the frame is used.
frame with a different CTAR specified, or the Continuous SCK mode is terminated.
SCK (CPOL = 0)
SCK (CPOL = 1)
Master SOUT
Master SIN
When in Continuous SCK mode, for the SPI transfer CTAR0
should always be used, and the TXFIFO must be cleared using
the MCR[CLR_TXF] field before initiating transfer.
PCS
Figure 42-76. Continuous SCK Timing Diagram (CONT=0)
K30 Sub-Family Reference Manual, Rev. 6, Nov 2011
NOTE
t
DT
Chapter 42 SPI (DSPI)
1109