MK30DN512ZVLK10 Freescale Semiconductor, MK30DN512ZVLK10 Datasheet - Page 619

• Manufacturer Part Number: MK30DN512ZVLK10
• Description: ARM Microcontrollers - MCU KINETIS 512K SLCD
• Manufacturer: Freescale Semiconductor

Specifications of MK30DN512ZVLK10

• Core: ARM Cortex M4
• Processor Series: K30
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 128 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.71 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-80
• Mounting Style: SMD/SMT

28.4.10.7 Erase Flash Sector Command
The Erase Flash Sector operation erases all addresses in a Flash sector.
1. Must be phrase aligned (flash address [2:0] = 000).
After clearing CCIF to launch the Erase Flash Sector command, the FTFL erases the
selected program flash sector and then verifies that it is erased. The Erase Flash Sector
command aborts if the selected sector is protected (see the description of the FPROT
registers). The swap indicator address in each program flash block is implicitly protected
from sector erase unless the swap system is in the UPDATE or UPDATE-ERASED state
and the program flash sector containing the swap indicator address being erased is the
non-active block. If the erase-verify fails the FSTAT[MGSTAT0] bit is set. The CCIF
flag is set after the Erase Flash Sector operation completes. The Erase Flash Sector
command is suspendable (see the FCNFG[ERSSUSP] bit and
Freescale Semiconductor, Inc.
Program flash is selected and the address is out of program flash range
Flash address is not longword aligned
Any area of the selected flash block is protected
Any errors have been encountered during the verify operation
Command not available in current mode/security
An invalid Flash address is supplied
Flash address is not phrase aligned
The selected program flash sector is protected
Any errors have been encountered during the verify operation
Error Condition
Error Condition
FCCOB Number
0
1
2
3
Table 28-42. Erase Flash Block Command Error Handling (continued)
Table 28-43. Erase Flash Sector Command FCCOB Requirements
Table 28-44. Erase Flash Sector Command Error Handling
K30 Sub-Family Reference Manual, Rev. 6, Nov 2011
Flash address [23:16] in the flash sector to be erased
Flash address [15:8] in the flash sector to be erased
Flash address [7:0]
FCCOB Contents [7:0]
0x09 (ERSSCR)
1
in the flash sector to be erased
Chapter 28 Flash Memory Module (FTFL)
Figure
28-25).
FSTAT[MGSTAT0]
FSTAT[MGSTAT0]
FSTAT[ACCERR]
FSTAT[ACCERR]
FSTAT[ACCERR]
FSTAT[ACCERR]
FSTAT[ACCERR]
FSTAT[FPVIOL]
FSTAT[FPVIOL]
Error Bit
Error Bit
619