MK30DN512ZVLK10 Freescale Semiconductor, MK30DN512ZVLK10 Datasheet - Page 205

• Manufacturer Part Number: MK30DN512ZVLK10
• Description: ARM Microcontrollers - MCU KINETIS 512K SLCD
• Manufacturer: Freescale Semiconductor

Specifications of MK30DN512ZVLK10

• Core: ARM Cortex M4
• Processor Series: K30
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 128 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.71 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-80
• Mounting Style: SMD/SMT

9.14 Debug in Low Power Modes
In low power modes in which the debug modules are kept static or powered off, the
debugger cannot gather any debug data for the duration of the low power mode. In the
case that the debugger is held static, the debug port returns to full functionality as soon as
the low power mode exits and the system returns to a state with active debug. In the case
that the debugger logic is powered off, the debugger is reset on recovery and must be
reconfigured once the low power mode is exited.
Power mode entry logic monitors Debug Power Up and System Power Up signals from
the debug port as indications that a debugger is active. These signals can be changed in
RUN, VLPR, WAIT and VLPW. If the debug signal is active and the system attempts to
enter stop or VLPS, FCLK continues to run to support core register access and trace. In
these modes in which FCLK is left active the debug modules have access to core registers
but not to system memory resources accessed via the crossbar.
With debug enabled, transitions from Run directly to VLPS are not allowed and result in
the system entering Stop mode instead. Status bits within the MDM-AP Status register
can be evaluated to determine this pseudo-VLPS state. Note with the debug enabled,
transitions from Run--> VLPR --> VLPS are still possible but also result in the system
entering Stop mode instead.
In VLLS mode all debug modules are powered off and reset at wakeup. In LLS mode, the
debug modules retain their state but no debug activity is possible.
Going into a VLLSx mode causes all the debug controls and settings to be reset. To give
time to the debugger to sync up with the HW, the MDM-AP Control register can be
configured hold the system in reset on recovery so that the debugger can regain control
and reconfigure debug logic prior to the system exiting reset and resuming operation.
Freescale Semiconductor, Inc.
• The DWT can be configured to emit PC samples at defined intervals, and to emit
interrupt event information.
• Sleep cycles
• CPI (all instruction cycles except for the first cycle)
• Interrupt overhead
When using cJTAG and entering LLS mode, the cJTAG
controller must be reset on exit from LLS mode.
An event is emitted each time a counter overflows.
K30 Sub-Family Reference Manual, Rev. 6, Nov 2011
NOTE
NOTE
Chapter 9 Debug
205