MK30DN512ZVLK10 Freescale Semiconductor, MK30DN512ZVLK10 Datasheet - Page 626

• Manufacturer Part Number: MK30DN512ZVLK10
• Description: ARM Microcontrollers - MCU KINETIS 512K SLCD
• Manufacturer: Freescale Semiconductor

Specifications of MK30DN512ZVLK10

• Core: ARM Cortex M4
• Processor Series: K30
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 128 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.71 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-80
• Mounting Style: SMD/SMT

Flash Operation in Low-Power Modes
After clearing CCIF to launch the Program Once command, the FTFL first verifies that
the selected record is erased. If erased, then the selected record is programmed using the
values provided. The Program Once command also verifies that the programmed values
read back correctly. The CCIF flag is set after the Program Once operation has
completed.
The reserved program flash 0 IFR location accessed by the Program Once command
cannot be erased and any attempt to program one of these records when the existing value
is not Fs (erased) is not allowed. Valid record index values for the Program Once
command range from 0x00 to 0x0F. During execution of the Program Once command,
any attempt to read addresses within program flash 0 returns invalid data.
1. If a Program Once record is initially programmed to 0xFFFF_FFFF, the Program Once command is allowed to execute
28.4.10.12 Erase All Blocks Command
The Erase All Blocks operation erases all flash memory, verifies all memory contents,
and releases MCU security.
After clearing CCIF to launch the Erase All Blocks command, the FTFL erases all
program flash memory, program flash 1 IFR space, then verifies that all are erased.
If the FTFL verifies that all flash memories were properly erased, security is released by
setting the FSEC[SEC] field to the unsecure state and the FCNFG[RAMRDY] bit is set.
The Erase All Blocks command aborts if any flash region is protected. The swap
indicator address in each program flash block is not implicitly protected from the Erase
626
Command not available in current mode/security
An invalid record index is supplied
The requested record has already been programmed to a non-FFFF value
Any errors have been encountered during the verify operation
Error Condition
again on that same record.
FCCOB Number
FCCOB Number
Table 28-52. Program Once Command FCCOB Requirements (continued)
7
0
Table 28-54. Erase All Blocks Command FCCOB Requirements
Table 28-53. Program Once Command Error Handling
K30 Sub-Family Reference Manual, Rev. 6, Nov 2011
Program Once Byte 3 value
FCCOB Contents [7:0]
FCCOB Contents [7:0]
0x44 (ERSALL)
1
Freescale Semiconductor, Inc.
FSTAT[MGSTAT0]
FSTAT[ACCERR]
FSTAT[ACCERR]
FSTAT[ACCERR]
Error Bit