MK30DN512ZVLK10 Freescale Semiconductor, MK30DN512ZVLK10 Datasheet - Page 886

• Manufacturer Part Number: MK30DN512ZVLK10
• Description: ARM Microcontrollers - MCU KINETIS 512K SLCD
• Manufacturer: Freescale Semiconductor

Specifications of MK30DN512ZVLK10

• Core: ARM Cortex M4
• Processor Series: K30
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 128 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.71 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-80
• Mounting Style: SMD/SMT

Functional Description
36.4.14 Deadtime Insertion
The deadtime insertion is enabled when (DTEN = 1) and (DTVAL[5:0] is non- zero).
DEADTIME register defines the deadtime delay that can be used for all FTM channels.
The DTPS[1:0] bits define the prescaler for the system clock and the DTVAL[5:0] bits
define the deadtime modulo (number of the deadtime prescaler clocks).
The deadtime delay insertion ensures that no two complementary signals (channels (n)
and (n+1)) drive the active state at the same time.
If POL(n) = 0, POL(n+1) = 0, and the deadtime is enabled, then when the channel (n)
match (FTM counter = C(n)V) occurs, the channel (n) output remains at the low value
until the end of the deadtime delay when the channel (n) output is set. Similarly, when the
channel (n+1) match (FTM counter = C(n+1)V) occurs, the channel (n+1) output remains
at the low value until the end of the deadtime delay when the channel (n+1) output is set.
See the following figures.
If POL(n) = 1, POL(n+1) = 1, and the deadtime is enabled, then when the channel (n)
match (FTM counter = C(n)V) occurs, the channel (n) output remains at the high value
until the end of the deadtime delay when the channel (n) output is cleared. Similarly,
when the channel (n+1) match (FTM counter = C(n+1)V) occurs, the channel (n+1)
output remains at the high value until the end of the deadtime delay when the channel (n
+1) output is cleared.
886
• It is expected that the software output control feature be
• The CH(n)OC and CH(n+1)OC bits should be equal.
• The COMP bit should not be modified when software
• Software output control has the same behavior with
used only in combine mode.
output control is enabled, that is, CH(n)OC = 1 and/or
CH(n+1)OC = 1.
disabled or enabled FTM counter (see the CLKS bitfield
description in the Status and Control register).
K30 Sub-Family Reference Manual, Rev. 6, Nov 2011
Note
Freescale Semiconductor, Inc.