DF3052BX25V Renesas Electronics America, DF3052BX25V Datasheet - Page 170

• Manufacturer Part Number: DF3052BX25V
• Description: MCU 5V 512K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of DF3052BX25V

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 6 Bus Controller
DMAC: When the DMAC receives an activation request, it requests the bus right from the bus
arbiter. If the DMAC is bus master and the refresh controller or an external bus master requests the
bus, the bus arbiter transfers the bus right from the DMAC to the bus master that requested the
bus. The bus right is transferred at the following times.
The bus right is transferred when the DMAC finishes transferring 1 byte or 1 word. A DMAC
transfer cycle consists of a read cycle and a write cycle. The bus right is not transferred between
the read cycle and the write cycle.
There is a priority order among the DMAC channels. For details see section 8.4.9, Multiple-
Channel Operation.
Refresh Controller: When a refresh cycle is requested, the refresh controller requests the bus
right from the bus arbiter. When the refresh cycle is completed, the refresh controller releases the
bus. For details see section 7, Refresh Controller.
External Bus Master: When the BRLE bit is set to 1 in BRCR, the bus can be released to an
external bus master. The external bus master has highest priority, and requests the bus right from
the bus arbiter by driving the BREQ signal low. Once the external bus master gets the bus, it keeps
the bus right until the BREQ signal goes high. While the bus is released to an external bus master,
the H8/3052BF holds the address bus and data bus control signals (AS, RD, HWR, and LWR) in
: n = 7 to 0), and holds the BACK
the high-impedance state, holds the chip select signals high (CS
n
pin in the low output state.
The bus arbiter samples the BREQ pin at the rise of the system clock ( ). If BREQ is low, the bus
is released to the external bus master at the appropriate opportunity. The BREQ signal should be
held low until the BACK signal goes low.
When the BREQ pin is high in two consecutive samples, the BACK signal is driven high to end
the bus-release cycle.
Rev. 3.00 Mar 21, 2006 page 140 of 814
REJ09B0302-0300