DF3052BX25V Renesas Electronics America, DF3052BX25V Datasheet - Page 265

• Manufacturer Part Number: DF3052BX25V
• Description: MCU 5V 512K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of DF3052BX25V

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

8.4.11
NMI interrupts do not affect DMAC operations in short address mode.
If an NMI interrupt occurs during a transfer in full address mode, the DMAC suspends operations.
In full address mode, a channel is enabled when its DTE and DTME bits are both set to 1. NMI
input clears the DTME bit to 0. After transferring the current byte or word, the DMAC releases the
bus to the CPU. In normal mode, the suspended transfer resumes when the CPU sets the DTME
bit to 1 again. Check that the DTE bit is set to 1 and the DTME bit is cleared to 0 before setting
the DTME bit to 1.
Figure 8.21 shows the procedure for resuming a DMA transfer in normal mode on channel 0 after
the transfer was halted by NMI input.
For information about NMI interrupts in block transfer mode, see section 8.6.6, NMI Interrupts
and Block Transfer Mode.
Figure 8.21 Procedure for Resuming a DMA Transfer Halted by NMI (Example)
Resuming DMA transfer
DMA transfer continues
NMI Interrupts and DMAC
in normal mode
Set DTME to 1
DTME = 0
Yes
DTE = 1
No
1
2
End
1. Check that DTE = 1 and DTME = 0.
2. Read DTCRB while DTME = 0,
Rev. 3.00 Mar 21, 2006 page 235 of 814
then write 1 in the DTME bit.
Section 8 DMA Controller
REJ09B0302-0300