DS72030W200FPV Renesas Electronics America, DS72030W200FPV Datasheet - Page 198

• Manufacturer Part Number: DS72030W200FPV
• Description: MPU, 32BIT, SH7203, ROMLESS, 240QFP
• Manufacturer: Renesas Electronics America
• Series: SH7200r

Specifications of DS72030W200FPV

• Core Size: 32bit
• Program Memory Size: 32KB
• Cpu Speed: 200MHz
• Digital Ic Case Style: QFP
• No. Of Pins: 240
• Supply Voltage Range: 1.1V To 1.3V
• Operating Temperature Range: -20°C To +85°C
• Svhc: No SVHC
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Section 6 Interrupt Controller (INTC)
checked by reading the IRQ interrupt request bits (IRQ7F to IRQ0F) in the IRQ interrupt request
register (IRQRR).
When using edge-sensing for IRQ interrupts, an interrupt request is detected due to change of the
IRQ7 to IRQ0 pin states, and an interrupt request signal is sent to the INTC. The result of IRQ
interrupt request detection is retained until that interrupt request is accepted. Whether IRQ
interrupt requests have been detected or not can be checked by reading the IRQ7F to IRQ0F bits in
IRQRR. Writing 0 to these bits after reading them as 1 clears the result of IRQ interrupt request
detection.
The IRQ interrupt exception handling sets the I3 to I0 bits in SR to the priority level of the
accepted IRQ interrupt.
When returning from IRQ interrupt exception service routine, execute the RTE instruction after
confirming that the interrupt request has been cleared by the IRQ interrupt request register
(IRQRR) so as not to accidentally receive the interrupt request again.
6.4.5
PINT Interrupts
PINT interrupts are input from pins PINT7 to PINT0. Input of the interrupt requests is enabled by
the PINT enable bits (PINT7E to PINT0E) in the PINT interrupt enable register (PINTER). For
the PINT7 to PINT0 interrupts, low-level or high-level detection can be selected individually for
each pin by the PINT sense select bits (PINT7S to PINT0S) in interrupt control register 2 (ICR2).
A single priority level in a range from 0 to 15 can be set for all PINT7 to PINT0 interrupts by bits
15 to 12 in interrupt priority register 05 (IPR05).
When using low-level sensing for the PINT7 to PINT0 interrupts, an interrupt request signal is
sent to the INTC while the PINT7 to PINT0 pins are low. An interrupt request signal is stopped
being sent to the INTC when the PINT7 to PINT0 pins are driven high. The status of the interrupt
requests can be checked by reading the PINT interrupt request bits (PINT7R to PINT0R) in the
PINT interrupt request register (PIRR). The above description also applies to when using high-
level sensing, except for the polarity being reversed. The PINT interrupt exception handling sets
the I3 to I0 bits in SR to the priority level of the PINT interrupt.
When returning from IRQ interrupt exception service routine, execute the RTE instruction after
confirming that the interrupt request has been cleared by the PINT interrupt request register
(PIRR) so as not to accidentally receive the interrupt request again.
Rev. 3.00 Sep. 28, 2009 Page 166 of 1650
REJ09B0313-0300