DK-DEV-4SGX230N Altera, DK-DEV-4SGX230N Datasheet - Page 357

KIT DEVELOPMENT STRATIX IV

DK-DEV-4SGX230N

Manufacturer Part Number
DK-DEV-4SGX230N
Description
KIT DEVELOPMENT STRATIX IV
Manufacturer
Altera
Series
Stratix® IVr
Type
FPGAr

Specifications of DK-DEV-4SGX230N

Contents
Development Board, Universal Power Supply, Cables and Software
Silicon Manufacturer
Altera
Core Architecture
FPGA
Core Sub-architecture
Stratix
Silicon Core Number
EP4S
Silicon Family Name
Stratix IV GX
Rohs Compliant
Yes
For Use With/related Products
EP4SGX230K
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
544-2594

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
DK-DEV-4SGX230N
Manufacturer:
Altera
Quantity:
135
Part Number:
DK-DEV-4SGX230N
Manufacturer:
ALTERA
0
Chapter 10: Configuration, Design Security, and Remote System Upgrades in Stratix IV Devices
Fast Active Serial Configuration (Serial Configuration Devices)
April 2011 Altera Corporation
Programming Serial Configuration Devices
f
Serial configuration devices are non-volatile, flash-memory-based devices. You can
program these devices in-system using the USB-Blaster™, EthernetBlaster™, or
ByteBlaster™ II download cable. Alternatively, you can program them using the
Altera programming unit (APU), supported third-party programmers, or a
microprocessor with the SRunner software driver.
You can perform in-system programming of serial configuration devices using the
conventional AS programming interface or the JTAG interface solution.
Because serial configuration devices do not support the JTAG interface, the
conventional method to program them is using the AS programming interface. The
configuration data used to program serial configuration devices is downloaded using
programming hardware.
During in-system programming, the download cable disables device access to the AS
interface by driving the nCE pin high. Stratix IV devices are also held in reset by a low
level on nCONFIG. After programming is complete, the download cable releases nCE
and nCONFIG, allowing the pull-down and pull-up resistors to drive GND and V
respectively.
configuration device.
Altera has developed Serial FlashLoader (SFL), an in-system programming solution
for serial configuration devices using the JTAG interface. This solution requires the
Stratix IV device to be a bridge between the JTAG interface and the serial
configuration device.
For more information about SFL, refer to
Quartus II
Software.
Figure 10–9
shows the download cable connections for the serial
AN 370: Using the Serial FlashLoader with
Stratix IV Device Handbook Volume 1
CCPGM
10–23
,

Related parts for DK-DEV-4SGX230N